Наукові статті кафедри прикладної механіки та інженерії матеріалів

Permanent URI for this collectionhttp://er.nau.edu.ua/handle/NAU/35006

Browse

Browsing Наукові статті кафедри прикладної механіки та інженерії матеріалів by Author "Bashta, Oleksandr"

Filter results by typing the first few letters
Now showing 1 - 3 of 3
  • Thumbnail Image
    Item
    Arched transmissions teeth geometry within offset of initial profile
    (Національний авіаційний університет, 2019-10) Nosko, Pavlo; Носко, Павло; Bashta, Oleksandr; Башта, Олександр; Lysenko, Аndrii; Лисенко, Андрій; Tkach, Pavlo; Ткач, Павло; Bashta, Alla; Башта, Алла
    There has been researched teeth geometry of cylindrical arched teeth gears, cut with rod instrument, teeth of which profiled by arbitrary curve in normal cross-section and in linear direction within initial profile offset. Toothing of instrumental rod with arched teeth with gears within initial profile offset is an analogue of the process of cutting teeth with rod instrument by means of enveloping. Surfaces of gear teeth within toothing with rod are enveloping of teeth surfaces of the last one. If teeth surfaces of instrumental rods for cutting pinion teeth and gear are non-congruous, then we have case of dotty toothing of pinion and gear. If initial profiles are non-congruous, then contact dot moves from one side of the tooth to another. It was obtained equations of teeth surfaces, while writing down coordinates of toothing surfaces in coordinate systems X1Y1Z1 and X2Y2Z2, connected with pinion and gear. While making such a transition, we have equations of surfaces of convex side of pinion teeth and concave side of gear teeth. In common case those equations are equations of helical lines of variable pitch. These equations can be used within the determination of toothing field borders, appropriate to the tops of the pinion and the gear teeth. Within this case two types of toothed gears with arched teeth will differ: gears with symmetric arched teeth (teeth are symmetric relatively to the plane XOZ and asymmetric arched teeth (working area of teeth surface is situated from one side of plane). Received results can be used within the determination of indices of loading ability and other characteristics of cylindrical arched transmissions with generalized teeth geometry within initial profile offset.
  • No Thumbnail Available
    Item
    Design of worm gears with optimal geometric parameters based on minimization of losses in gearing
    (Національний авіаційний університет, 2018-02) Tkach, Pavlo; Nosko, Pavlo; Grygory, Boyko; Bashta, Oleksandr; Bashta, Alla
    The mathematical model of definition of losses in gearing worm gears and their decrease on 10 … 15 % is stated at definition on the basis of planning mathematical experiment of rational parameters of transfers.
  • Thumbnail Image
    Item
    Gearing with increased teeth wear resistance
    (Національний авіаційний університет, 2018-03) Tkach, Pavlo; Nosko, Pavlo; Bashta, Oleksandr; Boyko, Grygory; Tsybrii, Iurii; Gerasimova, Olga
    The most important criterions of gearing efficiency are teeth wear resistance. The order of synthesis of rack cutter instrument for manufacture of gears with increased teeth wear resistance is considered. It is based on the model of teeth wear of closed gearing that works in oil reservoir. The differential equation is derived; its solution determines geometrical parameters of original profile. The parameters depend on setpoint of comparative teeth wear of synthesizing gearing and involute gearing. The finding solution is used for creation of equation of working teeth surfaces in toothing.